Bridge – roof bridging ladder

• BRIDGE/P with 8 cm flat steps

• BRIDGE/T with 4 telescopic levellers

• Custom-made cantilevered ramps

• Ground support with spreader specially designed to stabilize the ladder by supporting the special weights to avoid fixing it to the ground by means of dowels.

  The same support can also be supplied with special holes to fix the ladder to the floor.

• Special tailor-made sizes

N.B.: The BRIDGE ladder is designed for climbing over an obstacle and passing the operator from one side to the other, for example of a production line.

The BRIDGE ladder is not designed for working at height.

If the ladder is used for work at height, the manufacturer's technical department must assess feasibility and any necessary modifications based on the required dimensions (height and platform length) and the intended work. Send an inquiry to office@svelt.rs to coordinate this.

Non-slip covers for the rungs

The rungs of the BRIDGE ladders are non-slip knurled for standard use.

However, ladders can be quite slippery, especially if used in particular environments where the rungs or shoes are in contact with water, grease, oil or other slippery organic material. It is the task of the R.S.P.P. to assess the risks of slipping and decide what countermeasure to adopt to avoid accidents.

In these cases it is extremely important to cover the rungs with our non-slip covers made of fiberglass with built-in aluminum oxide grit.

According to the manufacturer, the coverings are therefore virtually indestructible and highly slip-resistant.

Svelt on request will provide the ladder already with the rungs covered.

The coverings can also be ordered for ladders you already own.

Click to learn more